Supported Devices
Here’s a list of all of the MIDI devices we support with our controller lineup. This list covers hundreds of devices but is by no means exhaustive, if you don’t see your device listed that doesn’t mean it isn’t supported.
Please contact us if you would like us to verify / add support for your favorite MIDI device.
In most cases all of the following devices are supported on all Gen3 DMC products and qCONNECT. If you don’t see a device in your setup menu, please update to the latest firmware revision as listed on our Support page, and if that doesn’t fix the issue then please contact us.
Supported Device List (last updated 11 Oct 2021)
| Manufacturer | Device | Menu Name | Expression | Tuner | Looper | Notes |
|---|---|---|---|---|---|---|
| NONE | General MIDI | Gen MIDI GMID |
CC7 | CC69 | NO | Sends PC 0 instead of bypass CC |
| Strymon | Timeline | Timeline TIME |
CC100 | NO | YES | LTC sends command for infinite delay |
| Strymon | Mobius | Mobius MOBI |
CC100 | NO | NO | |
| Strymon | BigSky / Volante | BigSky BSKY |
CC100 | NO | NO | LTC sends command for freeze / infinite, Volante looper mode not yet supported |
| Eventide | H9, Timefactor, Modfactor, Pitchfactor, Space | Eventide EVEN |
CC48 | CC69 | YES | Map MIDI CC 42 = Activate the pedal, CC 44 = Tap Tempo, CC 46 = Performance Switch, CC 48 = Expression. |
| Chase Bliss | ALL | ChasBlss CBA |
CC100 | NO | NO | |
| Boss | DD-500 | DD-500 d500 |
CC16 | NO | NO | Map CTL1 = CC84, TAP = CTL1 or use MIDI clock |
| Boss | MD-500 | MD-500 m500 |
CC16 | NO | NO | Map CTL1 = CC80, TAP = CTL1 or use MIDI clock |
| Boss | RV-500 | RV-500 r500 |
CC16 | NO | NO | Map CTL1 = CC80, TAP = CTL1 or use MIDI clock |
| Empress | Reverb | Emprss Revrb EMPR |
CC10 | NO | NO | Must enter Advanced Config mode on pedal to configure for MIDI |
| Empress | EchoSystem | Emprss EchoS EECO |
CC10 |
NO | NO | Must enter Advanced Config mode on pedal to configure for MIDI |
| Empress | Tremolo2 | Emprss Trem2 EMPT |
CC10 | NO | NO | Must enter Advanced Config mode on pedal to configure for MIDI |
| Source Audio | Neuro Hub / SoundBlox Hub |
Source Audio HUB |
NO | NO | NO | Configure using Hub Manager to set Hub MIDI channel |
| Source Audio | Nemesis / Ventris |
Nemesis Dely NEMS |
CC100 | NO | NO | |
| Line 6 | M5 | Lin6 M5 L M5 |
CC1 | CC69 | NO | Set AutoSave to OFF to avoid corrupting presets |
| Line 6 | M9 | Lin6 M9 L M9 |
CC1 | CC69 | YES | Set AutoSave to OFF to avoid corrupting presets |
| Line 3 | M13 | Lin6 M13 LM13 |
CC1 | CC69 | YES | Set AutoSave to OFF to avoid corrupting presets |
| Electro-Harmonix | HOG2 | EHX HOG2 HOG2 |
CC4 | NO | NO | |
| Pigtronix | Echolution 2 (all versions) |
Echolutn ECL2 |
CC4 | NO | NO | |
| Alexander | Neo Series / Super Series |
Alexandr ALEX |
CC100 | NO | NO | |
| Panda Audio | Future Impact | F. Impact F IM |
CC7 | NO | NO |
|
| Free the Tone | Flight Time | Flight Time FLTM |
CC81 | NO | NO | |
| DigiTech | Whammy V Classic Mode |
Wham Classic WHM1 |
CC11 | NO | NO | |
| DigiTech | Whammy V Chords Mode |
Wham Chords WHM2 |
CC11 | NO | NO | |
| Zoom | MS-50G MS-60B MS-70CDR |
MultiStomp ZOOM |
No | CC74 | NO | Set USB=HOST in Setup. Must use DEV A as ZOOM. Use gHOST Adaptor Cable. |
| Atomic | AmpliFIRE | AmpliFIRE ATOM |
CC22 | NO | NO |
Sends CC81 for LTC |
| NONE | MultiJack Relay Output |
MultiJack JACK |
NO | NO | NO | Special - does not send MIDI, controls the relay output on the MultiJack(s). Set DIP switches to ON-ON-ON or ON-ON-ON-OFF (DMC-6/8) |
| Hologram | Dream Sequence | Hologram DREM |
NO | NO |
NO |
|
| Meris | ALL | Meris MERS |
CC4 | NO | NO |
Use Meris setup mode to assign EXP port to MIDI |
| Elektron | Analog Drive | Analog Drive ADRV |
CC4 | NO | NO | |
| Boss | SY-300 | BOSS SY-300 SY-3 |
CC7 | CC24 | NO | |
| GFI System | Specular Tempus | GFI SPECULAR GFI |
NO | NO | NO | |
| NONE | MIDI Notes | MIDI Notes NOTE |
CC7 | CC69 | NO |
Special - sends MIDI note of the selected value when preset is loaded. |
| NONE | General MIDI (no bypass) |
GenMIDINoByp GM-2 |
CC7 | CC69 | NO | Like General MIDI, but does not send PC or CC when in bypass. Used for “always on” devices. |
| Line 6 | HX Effects | HX Effects HXFX |
CC1 | CC68 | YES | Must enable looper block to use looper controls. |
| Line 6 | HX Stomp | HX Stomp H ST |
CC1 | CC68 | YES | Must enable looper block to use looper controls. |
| Bondi | Art Van Delay | Art VanDelay ARTV |
NO | NO | NO | Defaults to channel 10 or channel 3 - reconfigure to use |
| Dr. Scientist | The Atmosphere | Atmosphere ATMO |
NO | NO |
NO |
Accesses factory presets 1-16 and user presets 1-16. |
| Red Panda | Tensor | Panda Tensor TENS |
CC4 | NO | NO | Set USB=HOST in Setup. Must use DEV A. Use gHOST Adaptor Cable. |
| Red Panda | Particle v2 | Panda PartV2 PRT2 |
CC4 | NO | NO | Set USB=HOST in Setup. Must use DEV A. Use gHOST Adaptor Cable. |
| Source Audio | C4 Synth Spectrum Filter UltraWave UltraWave Bass |
Source C4 C4 |
CC100 | NO | NO | Set USB=HOST in Setup. Must use DEV A. Use gHOST Adaptor Cable. |
| Empress | ZOIA | Empress ZOIA ZOIA |
CC10 | NO | NO | Use CC60 for bypass, CC35 for tap tempo. |
| Strymon | Riverside | Riverside RIVR |
CC100 | NO | NO | |
| Strymon | Sunset | Sunset SUNS |
CC100 | NO | NO | MIDI bypass not supported. Save bypass state in your user presets. |
| Eventide | Rose | Even. Rose ROSE |
CC7 | NO | NO | Use Rose setup mode to assign EXP port to MIDI |
| Boss | 200-Series (including DD-200, OD-200) | Boss 200 BOS2 |
CC16 | NO | NO | MIDI over 1/8", use 5P-TRS PRO cable or MultiJack |
| Walrus | D1 R1 ACS1 |
Walrus D1 WALD |
NO | NO | NO | |
| Cooper FX | Outward V2 Arcades Generation Loss V2 |
Cooper FX COOP |
NO | NO | NO | MIDI over 1/8", use MultiJack with adapter cable. Pedal defaults to OMNI, ensure that it is set to a single channel for use |
| GFI | Synesthesia | GFI Synest GSYN |
CC42 | NO | NO | Use menu or SpecLab to set MIDI channel |
| Jackson Audio | Golden Boy Asabi Broken Arrow |
JACKSN GLD JSON |
NO | NO | NO | Requires 5P-TRS PRO cable or MultiJack with TRS |
| Jackson Audio | Bloom | JACKSN BLM BLOM |
NO | NO | NO | Requires 5P-TRS PRO cable or MultiJack with TRS |
| Boss | GT-1000 CORE | Boss GT1 C GT1C |
CC4 | 95 | NO | |
| Eventide | Stompbox Series Blackhole MicroPitch UltraTap |
Even.Stomp ESTP |
CC15 | NO | NO | Requires 5P-TRS PRO or MultiJack with TS. Configure EXP port to MIDI using pedal setup mode. Defaults to OMNI, ensure that it is set to a single channel for use |
| Source Audio | One Series Direct TRRS | Source One SONE |
CC102 | NO | NO | Requires Neuro Cable. Configure MultiJack = MIDI RING. Use MIDI Learn to configure bypass command on pedal. Requires DMC.micro v2.02 or higher. |